Serving Bristol, Bensalem and Morrisville24/7 Emergency Dispatch: (833) 840-2034
Levittown PA Plumbers Den badge logo, home link in the mobile header of the garbage disposal page
Emergency? Call now!(833) 840-2034

24/7 Emergency Line Open

Home › Services › Garbage Disposal

Garbage Disposal Plumbers | Humming, Jammed and Leaking Units Fixed in Levittown, PA

A disposal that hums and does not spin, backs the sink up or leaks into the cabinet is a kitchen problem that cannot wait long. A plumber from this line can repair or swap a garbage disposal and fix the drain and dishwasher connections around it.

Call (833) 840-2034
  • Licensed and insured plumbers
  • Same-day service when available
  • 24/7 emergency dispatch
Plumber in a blue shirt kneeling on a drop cloth at an open kitchen sink cabinet and tightening a pipe with a wrench, tools spread beside him
A drop cloth and an open cabinet are the usual setup for a disposal swap.

Garbage disposal repair

Most disposal complaints are about a jam, a reset or a loose joint, and not a dead motor. The plumber starts by turning the power off, then looks at the unit from above and below. Common repairs include clearing a jam, resetting the overload, replacing a leaking gasket or flange, and tightening the drain connections.

SymptomCommon causeTypical repair
Hums, blades will not turnJam from bone, pit or utensilClear the blades and reset
Nothing happens at allTripped reset, outlet or switch problemReset the unit and check power
Water under the sinkLeaking seal, flange or drain jointReplace the gasket or tighten the joint
Drain backs upClog in the trap or branch drainClear the trap and the line
Burnt smell or tripped breakerOverheated or failed motorReplace the unit
Hands outTurn the power off before any work and never put a hand into the unit. Use tongs or the hex key from below.

Install and replace

A new disposal means removing the old unit, cleaning the sink flange, mounting the new unit, connecting the drain and the dishwasher inlet, and wiring or plugging it in. The plumber picks a horsepower to match how you use it. A light-use household does fine with a smaller motor, while a large family that cooks every night is better served by a stronger one.

Mounting matters as much as the motor. A disposal hangs from the sink flange on a collar, and a collar that is not seated evenly lets water weep at the top and rattles under load. The plumber seats the gasket, tightens the ring in even turns and runs water through the unit before the cabinet is closed up. Power comes from a switch or a plug under the sink, and the plumber confirms the circuit suits the motor.

Replacement is also the time to check the trap, the drain pipe and the dishwasher hose, since those are the parts that leak next. The plumber tests for leaks with the water running before leaving.

Hands working at the round wiring cover on the bottom of a black garbage disposal with a white cable running to it
The power connection sits under a small cover, so the unit is unplugged or switched off at the panel before it is touched.

Disposal humming, jammed or leaking?

Say what it is doing when you call, and the dispatcher books a plumber for the repair or the swap.

Call (833) 840-2034 Contact details ›

Leaking disposals

A disposal can leak from three places, and where the water shows tells you which. A leak at the top is the sink flange or the mounting. A leak from the side is the dishwasher inlet or the drain outlet. A leak from the bottom or the housing itself means the unit has failed and should be replaced.

A leak should be fixed quickly. Water that drips into a cabinet soaks the floor, swells the particle board and grows into a bigger repair. If the cabinet is already wet, the fixture repair page covers the sink and supply lines under it.

Hands attaching a white drain pipe to the discharge outlet on the side of a black garbage disposal
The discharge outlet is a common spot for slow leaks, since the gasket there takes the vibration.

Jammed, clogged and backed up

A jam stops the blades. A clog stops the water. The two are different problems, though they often arrive together. If the sink holds water and the disposal hums, the jam and the clog may both be real. The plumber clears the blades first, then runs the trap and the line to confirm the sink drains at a normal pace. Grease, coffee grounds and fibrous scraps are the usual causes of a clog just past the disposal. A running dishwasher that backs up into the sink points to the same place, because the dishwasher drain joins the disposal outlet.

Dishwasher connection and drain

The dishwasher drains through the disposal in most kitchens, so a bad connection shows up as water in the machine, a gurgle at the sink or a leak at the inlet. When a new disposal goes in, the plumber knocks out the dishwasher plug if there is one, connects the hose with a clamp and checks that the drain loop is high enough to keep drain water from returning to the machine.

Need a disposal swapped?

Describe the old unit and the sink. A plumber confirms what the job takes.

Call (833) 840-2034 Contact details ›

When a plumber is the right call

A reset and a hex key are fair first tries. A plumber is the better call when the disposal leaks, smells burnt, trips the breaker, hums after a reset, or sits above a drain that will not clear. The same visit covers the trap, the drain pipe and the dishwasher connection, which are the usual reasons a disposal fails again.

  • A leak you cannot trace to a loose fitting
  • A unit that stays jammed after a reset
  • A breaker that trips whenever the switch is on
  • A sink that will not drain even with the disposal off
  • A disposal that is old, corroded or noisy

Garbage disposal questions

Should I repair or replace my garbage disposal?

A jam, a tripped reset or a loose connection is a repair. A disposal that leaks from the housing, has a seized motor or is many years old is usually a replacement. The plumber checks the unit, tells you which case it is and does the work in the same visit if the part is on the truck.

What does it mean when a disposal is jammed, humming or stuck?

A hum with no spin means the motor has power but the blades cannot turn, which is almost always a jam. Power to the unit should be off before anyone touches it. A plumber clears the jam from below with the hex key socket or from above with tongs, then presses the reset. If the unit still hums, the motor or the flywheel is failing.

Why is my garbage disposal humming and not spinning?

The motor is trying to turn but something is holding the flywheel, such as a bone, a fruit pit or a spoon. Turn the switch off at the wall first. Never put a hand in the unit. A plumber clears the blades, checks for damage and resets the overload button on the bottom. A unit that keeps jamming may be worn out.

Do I need a plumber for garbage disposal repair?

You can try the reset button and the hex key at the bottom of the unit when the power is off. A plumber is the safer choice when the disposal leaks, smells burnt, trips the breaker, or when the jam does not clear. A plumber also handles the dishwasher drain connection and the trap, which are the usual places a disposal leaks.

Book a disposal plumber

Repair or replacement, a single call books the visit.

Call (833) 840-2034 Contact details ›
  • Licensed and insured plumbers
  • Same-day service when available
  • 24/7 emergency dispatch
Call now, 24/7