24/7 Emergency Line Open
Home › Services › Water Softener & Filtration
Softeners and Water Filters | Install, Repair and Service for Levittown, PA Homes
White spots on glass, a film on the shower door and a water heater that scales up are the usual signs that water treatment would help. Plumbers sent from this line install, repair and service softeners and filters, and tell you what a given unit will and will not do.
Call (833) 840-2034- Licensed and insured plumbers
- Same-day service when available
- 24/7 emergency dispatch
Water softeners: what they do
A softener removes the minerals that cause scale by swapping them for sodium or potassium in a resin tank. The resin fills up, and the unit then regenerates with brine to start again. That cycle is why a softener has a salt tank, a control valve, a drain line and a bypass.
A softener treats hardness. It does not make water safe to drink, and it does not remove most contaminants. For drinking water quality you need a filter or a reverse osmosis system, and for a question about what is in the water, the supplier is the place to ask. Levittown water comes from the Delaware River and five wells, and no hardness number is published, so ask the supplier for its current water quality report.
Softener repair and service
Most softener trouble falls into a few groups, and the symptom tells you where to look.
| Symptom | Likely cause | What a plumber checks |
|---|---|---|
| Hard water is back | Empty salt, bridged salt or a stuck valve | Salt level, brine draw and control valve |
| Salt tank overflows | Stuck float or blocked drain line | Float, drain and overflow connections |
| Water runs to the drain constantly | Control valve or seal failure | Valve internals and the drain line |
| Low pressure after the softener | Clogged resin or a partly closed bypass | Resin bed, bypass and inlet screens |
| Salty taste | Brine drawn into the house | Valve and injector |
| Unit never regenerates | Timer or power fault | Controller and meter |
A softener that has been neglected for years often has a clogged injector or a fouled resin bed. The plumber says plainly whether it is worth repairing or time to replace.
Softener acting up?
Describe what the unit is doing, and the dispatcher books a plumber who can check the valve, the brine and the drain.
Call (833) 840-2034 Contact details ›
Softener installation
A new softener goes where the main water line enters the house, with room for a salt tank, a drain and a power outlet. The plumber sets the unit, connects the inlet, outlet and bypass, runs the drain with an air gap and wires the control. A bypass valve is part of any install, so the unit can be isolated for service without shutting the water to the house. Many original Levitt homes have the water entry in a utility closet or a crawl area rather than a basement, so the first step is to find a spot that suits the unit and the drain.
Whole-house filtration
A whole-house filter sits on the main line and treats all the water that enters the house. A sediment filter catches sand and rust. A carbon filter reduces chlorine taste and odor. The filter protects the fixtures and the water heater, and the plumber chooses the type from what you want to remove.
- Sediment filters for sand, silt and rust flakes
- Carbon filters for chlorine taste and odor
- Combination units that pair a filter with a softener
- Bypass and pressure gauges so the filter can be serviced
- Cartridges or media that need replacing on a schedule
A filter that is never changed becomes a restriction. Plan for the cartridge change when you pick the unit.
Reverse osmosis and under-sink filters
A reverse osmosis system treats the water at one tap, usually the kitchen. It pushes water through a membrane that removes a large share of dissolved material and sends the rest to the drain. It has its own faucet, a storage tank and a drain connection on the sink trap. An under-sink drinking water filter is simpler, with a cartridge and a small faucet, and no drain line.
Either system adds fittings under the sink, so the plumber checks the space, the supply and the drain. A leaking fitting under the sink is the classic failure, and the install includes a test with the water running.
Thinking about treating your water?
Mention what you notice at the tap, and a plumber recommends what suits the house.
Call (833) 840-2034 Contact details ›Hard water signs and testing
Hard water leaves marks you can see. Chalky spots on glass, scale on faucets and shower heads, a film on the tub and a scaled-up water heater are the usual ones. Soap that does not lather and dry, stiff laundry are others. A test strip or a lab test gives a number, and the supplier publishes a report on what is in the water at the tap.
Scale shortens the life of a heater, and the page on repairing the heater explains what that looks like inside the tank.
Salt, brine and regeneration
A softener uses salt to refresh its resin. Check the level every month or two, break up a salt bridge if one forms, and keep the lid closed. The unit regenerates on a schedule or after a set volume of water, and a plumber sets it for your household.
Water softener and filter questions
Something fell into my water softener brine well. Can a plumber get it out?
Yes. A dropped tool or a box cutter in the brine tank can damage the unit or injure a hand, so do not reach in blind. A plumber shuts the unit to bypass, removes the salt and brine as needed, retrieves the object and checks the tank, grid and float for damage. Keep the lid closed and the area clear until the work is done.
My fridge water line valve is failing and the softener overflowed. What now?
Close the shutoff for the softener and the fridge line, and mop up before the water reaches flooring. An overflow usually comes from a stuck float, a bad drain line or a failed valve, while the fridge line leaks at its own valve and tubing. A plumber replaces the failed valve, checks the drain and overflow, and tests the unit before putting it back in service.
Can a softener valve be replaced or reinstalled?
Yes. The control valve on top of the tank is a replaceable part, and a unit can also be reinstalled after a move or a remodel. The plumber shuts off the water, disconnects the unit, swaps or resets the valve and reconnects the bypass, drain and brine line. After the water is on, the unit is programmed and run through a regeneration to confirm it works.
Book a water treatment plumber
Install, repair or service, one call books the visit.
Call (833) 840-2034 Contact details ›- Licensed and insured plumbers
- Same-day service when available
- 24/7 emergency dispatch